Start
Insert ammo loader
Insert the Spring with the Ammo Loader in to the Black Cover
Insert The Metal Rod into the Ammo Loader.
Close Black Case.
Make Sure the Spring is pushed down so the Black Case can close.
Insert the two Clip Screws. Also insert the bottom of the Black case.
Insert the Black Case into the outer shell (not needed now though).
Insert the Y-Shaped Spring into the Mechanism.
Insert the Other half of the Mechanism on and also insert the ammo connector.
It should look like this. Disregard the screw.
Attach the black spring holder to the mechanism.
This is where the mechanism is inserted into.
This is the metal rod with indent and the rubber cap.
Place the rod with the cap into the black mold.
Place the small black rod below the metal rod with indent. Also place the other half of the mold on.
Screw in the metal screws in place and attach the medium spring on the small black rod.
Ths is where the trigger goes. Secure it with a black holder into a small hole in the side.
Place the large spring onto the black spring holder.
Place the black loader onto the spring and pull it back so it clicks in.
Insert a black holder ot secure the mechanism.
Connect the black mold to the black holder, and insert the black plastic nail into where it is seen in the picture.
Place the decorative model into the Airsoft.
It goes onto the metal rod with indent.
Place the nozzle over the metal rod with indent.
It should look like this now.
Pull back, and place the upper part of the outer case on.
It's done.
